How do I install a front wheel motor on my e-bike? Helokeep ME-T and Globalkeep MG-T dual motor e-bike

This tutorial applies to all dual motor E-Bikes from Helokeep ME-T and Globalkeep MG- T dual motor e-bike.

1.Confirm the accessories and quantity for installing the front motor, all as shown in the picture.

Nut*2
Thin washer*2
Hook washer*2
Motor anti-fall-off bracket*2
Motor anti-fall-off bracket screw*2

2.Confirm the order of nuts and washers. Right side: hook washer inside, thin washer and nut outside. Left side: hook washer inside, thin washer and nut outside. Connect the front fork between the hook washer and the washer.

3.Motor anti-fall-off bracket.

4.Install the front fork.

5. Confirm again and tighten all screws. Then test the bike at a low speed.